Energy UNITS FOR LIFT TABLE one
General Description
This power unit is designed solely to the modest lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit is broadly employed inside the marketplace of logistic units for example minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is controlled by the solenoid valve together with the pace controlled through the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Basic Description
This electrical power unit is made solely for your medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve plus the speed managed by the adjustable needle valve. Once the lift rises to a substantial positoin, however the energy supply is minimize, the decreasing movement is managed by the manual override function.
Power UNITS FOR LIFT TABLE three
Basic Description
This power unit is designed exclusively for that huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve as well as the pace controlled by a strain compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE four
Basic Description
This energy unit is made exclusively to the huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and also the velocity controlled by the adjustable needle valve. Once the lift rises to a large positoin, but the power provide is minimize, the lowering movement is managed through the guide override function.
Distinctive Notes
1. This energy unit is of S3 duty cycle, which could only operate intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean every one of the hydraulic components concerned in advance of set up of the electrical power unit.
3. Viscosity of the oil shoud be 15~46 cst,which must also be clean and no cost of impurities.N46 hydraulic oil is advised.
4. Oil modifying is needed immediately after the original one hundred operation hours,afterwards after just about every 3000 hrs.
5. The energy unit proven is made to be mounted vertically.
Energy UNITS FOR LIFT TABLE
Tags: