Consisting of a strain balanced gear pump, DC motor, multi-functional manifold, valves, tank, ect., this energy unit is designed to operate materials handling gear. The lowering movement is achived through the solenoid valve with all the lowering pace managed by an adjustable needle valve. The left and right functions are outfitted with a dual pilot operated check out valve and cross-over relief valves.
Remark: Please talk to our revenue engineer for the different pump displacement, motor electrical power or tank capacity.
one. This power unit is of S3 duty cycle, i.e.,non-continuous operation,thirty seconds on and 270 seconds off.
two. Clean every one of the hydraulic parts concerned in advance of installation of the energy unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst, which should also be clean and no cost of impurities.N46 hydraulic oil is advised.
four. This power unit must be mounted horizontal.
five. Check the oil degree while in the tank following the very first commence in the energy unit.
6. Oil changing is required immediately after the original a hundred operation hours, afterwards as soon as each and every 3000 hours.
SNOW PLOW Power UNIT