one.A connecting website link of an O-ring Chain for general application is pre-coated with grease on the pins. In advance of connection, verify the grease over the surfaces of pins, and when the amount of grease is smaller, apply grease with bare hands. (If gloves are applied, the grease will likely be absorbed through the gloves.)
Illustration: When the connecting website link (I) of an O-ring chain for basic application is
shipped, O-rings are fitted on the roots with the pins. In case the O-rings come loose resulting from vibration throughout transport, refit the O-rings in towards the roots in the pins.
In this case, make sure to return the grease collected in the roots on the pins on the central surfaces with the pins, far more at portion A than at portions B shown inside the above illustration. (Portions A is worn as a consequence of sliding with all the bushings.)
two.The chain is usually most simply linked over the teeth of the sprocket. Engage the hyperlinks at the two ends from the chain with the sprocket teeth and match connecting pins. Should the sprocket can be moved, the chain may also be connected to the loosened side.
3. Connecting process
one.Confirm that O-rings are connected for the roots of your pins.
two.If the level of grease utilized on the connecting pins is compact, coat the pins with grease at the central portions.
three.Insert the connecting pins to the bushings of your inner links at both ends.
four.Verify that the grease is applied on the total face in the O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins to the connecting plate and when pressing the connecting plate, set up the spring clip. Verify no matter whether the head (the finish with no split) of the spring clip is turned while in the feeding route of your chain. (See the next illustration.)
six.Be sure you confirm the spring clip is securely fitted within the clip grooves from the connecting pins.
This completes jointing of your connecting hyperlink. Note that grease on the surfaces of connecting pins and O-rings is usually eliminated all through installation get the job done. In this instance, re-grease employing the grease about the surface of the base chain or the grease inside the polyethylene bag in which the connecting hyperlink was contained.